Renesas公司的RX63N是100MHz 32位RX MCU ,165DMIPS性能,集成了多达2MB闪存,以太网MAC,全速USB 2.0主/功能/OTG接口,包括CAN的各种通信接口,10位和12位ADC和RTC.和现有产品相比,待机功耗降低大约90%,工作电压2.7- 3.6V,主要用在音频设备,马达控制,游戏机和通信设备.本文介绍了RX63N主要特性,方框图,RX63N开发套件应用和特性,方框图,电路图和材料清单.

The RX63N/RX631 Group incorporates communication functions suitable for networking equipment, such as Ethernet controller, USB 2.0 full-speed (function, host, or OTG selectable), and CAN. In addition, with a RTC (Real-Time Clock) that can operate on a dedicated power supply as a low power feature, standby power consumption can be reduced by approximately 90% compared to existing products. The selection of on-chip memory has been expanded from ROMless to 2 MB, and even smaller-sized packages are available. This makes possible mounting in anything from large-scale systems to small-scale/small-space devices.

RX63N主要特性:

 32-bit RX CPU core

 Max. operating frequency: 100 MHz

 Capable of 165 DMIPS in operation at 100 MHz

 Single precision 32-bit IEEE-754 floating point

 Two types of multiply-and-accumulation unit (between memories and between registers)

 32-bit multiplier (fastest instruction execution takes one CPU clock cycle)

 Divider (fastest instruction execution takes two CPU clock cycles)

 Fast interrupt

 CISC Harvard architecture with 5-stage pipeline

 Variable-length instructions: Ultra-compact code

 Supports the memory protection unit (MPU)

 JTAG and FINE (two-line) debugging interfaces

 Low-power design and architecture

 Operation from a single 2.7- to 3.6-V supply

 Low power consumption: A product that supports all peripheral functions draws only 500uA/MHz.

 RTC is capable of operation from a dedicated power supply (min. Operating voltage: 2 V).

 Four low-power modes

 On-chip main flash memory, no wait states

 Supports ROM-less versions and versions with up to 2 Mbytes of ROM (ROM-less version: RX631 Group only)

 100-MHz operation, 10-ns read cycle (no wait states)

 384-Kbyte to 2-Mbyte capacities

 User code programmable via the USB, SCI, or JTAG

 On-chip data flash memory

 ROM-less or 32 Kbytes of ROM (reprogrammable up to 100,000 times)

 Programming/erasing as background operations (BGOs)

 On-chip SRAM, no wait states

 32- to 128-Kbyte capacities

 For instructions and operands

 Can provide backup on deep software standby

 DMA

 DMAC: Four channels

 DTC

 EXDMAC: Two channels

 Dedicated DMAC for the Ethernet controller: Single channel

 Reset and supply management

 Power-on reset (POR)

 Low voltage detection (LVD) with voltage settings

 Clock functions

 External crystal oscillator or internal PLL for operation at 4 to 16 MHz

 Internal 125-kHz LOCO and 50-MHz HOCO

 Dedicated 125-kHz LOCO for the IWDT

 Real-time clock

 Adjustment functions (30 seconds, leap year, and error)

 Time capture function (for capturing times in response to event-signal input on external pins)

 Independent watchdog timer

 125-kHz LOCO clock operation

 Useful functions for IEC60730 compliance

 Oscillation-stoppage detection, frequency measurement, CRC, IWDT, selfdiagnostic function for the A/D converter, etc.

 Various communications interfaces

 Ethernet MAC (1) (not in RX631 Group products)

 Host/function or OTG controller (1) and function controller (1) with fullspeed USB 2.0 transfer

 CAN (compliant with ISO11898-1), incorporating 32 mailboxes (up to 3 modules)

 SCI with multiple functionalities (up to 13)

 Choose from among asynchronous mode, clock-synchronous mode, smartcard interface mode, simplified SPI, simplified I2C, and extended serial mode.

I2C bus interface for transfer at up to 1 Mbps (up to 4)

 RSPI for high-speed transfer (up to 3)

 External address space

 Buses for high-speed data transfer (max. operating frequency of 50 MHz)

 8 CS areas (8 ⊙ 16 Mbytes)

 Multiplexed address data or separate address lines are selectable per area.

 8-, 16-, or 32-bit bus space is selectable per area

 Independent SDRAM area (128 Mbytes)

 Up to 20 extended-function timers

 16-bit MTU2: input capture, output compare, PWM waveform output, phase-counting mode (6 channels)

 16-bit TPU: input capture, output compare, phase-counting mode (12 channels)

 8-bit TMR (4 channels)

 16-bit compare-match timers (4 channels)

 A/D converter for 1-MHz Operation

 Up to 21 12-bit channels, and incorporating 1 sample-and-hold circuit

Up to 8 10-bit channels, and incorporating 1 sample-and-hold circuit

 Addition of results of A/D conversion (in the 12-bit converter)

 Self diagnosis (for the 10-bit converter)

 10-bit D/A converter: 2 channels

 Temperature sensor for measuring temperature within the chip

 Register write protection can protect values in important registers against overwriting.

 Up to 134 pins for GPIO

 5-V tolerance, open drain, input pull-up, switchable driving ability

 Operating temp. range -40 degree C to +85 degree C

图1。RX63N方框图

RX63N开发套件

Renesas Demonstration Kit (RDK) for RX63N

This RDK is an evaluation and demonstration tool for Renesas RX63N microcontrollers. The goal is to provide the user with a powerful debug and demonstration platform targeted at common applications. A set of human/machine interfaces are tightly integrated with the features of the RX63N and the software demonstration programs providing the user with an accessible platform to rapidly evaluate and customize.

RX63N开发套件应用和特性:

• Audioo

Stereo audio driver connected to the PWM interface

On-board microphone to demonstrate sampling, FFT/FPU capabilities

Volume Control Potentiometer

Micro SD card interface for audio and data files

• Motor Control

3 –Phase motor control algorithm representation with LEDs

Motor control algorithm speed variation through volume control potentiometer

• Gaming

3 –Axis Accelerometer (Digital)

User pushbutton switches

• Communications

10/100 Ethernet Interface connected to an internal Ethernet MAC (1588 compatible)

USB Interface connected to an internal USB controller (Host, Device and OTG)

RS-232 Interface

CAN Interface

I2C, SPI with Debug through the Beagle connector from Total Phase

PMOD connections to support a variety of generic PMOD devices (WiFi, Bluetooth, RF, and much more).

• User Code and Application Debugging

On-board J-Link OB for high-quality source code debugging


图2。RX63N开发套件外形图

图3。RX63N开发套件方框图

图4。RX63N开发板电路图（1）

图5。RX63N开发板电路图（2）

图6。RX63N开发板电路图（3）

图7。RX63N开发板电路图（4）

图8。RX63N开发板电路图（5）

图9。RX63N开发板电路图（6）

图10。RX63N开发板电路图（7）

图11。RX63N开发板电路图（8）

RX63N开发板材料清单见:
RX63N开发板材料清单.xls

详情请见:
http://documentation.renesas.com/doc/products/mpumcu/doc/rx_family/r01ds0098ej0100_63n631.pdf
和
http://am.renesas.com/media/products/tools/introductory_evaluation_tools/renesas_demo_kits/yrdkrx63n/sub/YRDKRX63N_user_manual_10.pdf

以及
http://am.renesas.com/media/products/tools/introductory_evaluation_tools/renesas_demo_kits/yrdkrx63n/sub/Schematics_YRDKRX63N_SCH_3.pdf